How to use the Hug Block

How to use the Hug Block

While watching how to make a two-tier box,
Here we will introduce the basic usage of Hug Block.

How to use Hug Block 1

Measure the area where you want to install it and calculate the size of the lumber you need.
*Cut the wood to a size that subtracts the thickness of the L-shaped Hug Block and T-shaped Hug Block.
* Click here for the plate size calculation chart

How to use Hug Block 2

Refer to the Hug Block instruction manual and use a hex wrench to loosen the bolts on the Hug Block (turn left), then insert the board and temporarily secure it (turn right).

How to use Hug Block 3

Tighten the T-type screws evenly on both sides.
*When using wood that is 15 mm or thicker, replace the short bolt (right) with the long bolt (left) included.

How to use Hug Block 4

Once you have checked that there is no distortion, tighten the bolts all the way to complete the process.
* To prevent wobbling, you can use screws to fasten the board. Use tapping screws that are shorter than the board thickness.



← Back to HUG BLOCK Top Page
Back to blog